BrosTrend WiFi Extender Not Showing Up [Troubleshooting]
When the BrosTrend WiFi extender denies appearing on the network list, it becomes difficult for you to access internet on wireless networking gadgets. In other words, you won’t be able to make video calls, listen to your favorite music, and even cannot access the BrosTrend WiFi extender setup wizard. Walk through the post and learn how to fix the BrosTrend WiFi extender not showing up issue.
Why Is Your WiFi Extender Not Showing Up?
Multiple reasons are there when you cannot see the SSID of your BrosTrend on the WiFi list. Below, we have penned down a few of them. This is to inform you that if you address these reasons, then you will be able to get rid of the issue effectively.
- Interference due to electronic gadgets and reflexive surfaces
- A pending firmware update
- Improper setup of the range extender
- Extender in a boot loop
Before everything else, be very sure that you’re trying to connect to correct network. Check the extender’s SSID from the local interface.
Fixed: BrosTrend WiFi Extender Not Showing Up
1. Ensure Stable Power Supply
You can’t expect your range extender to show up on your WiFi devices if it is not fully powered up. The best method to check this is to verify whether the Power light of the extender is ON or OFF. If not, we suggest you plug the range extender into another but working wall outlet. Please take care that your extender lies in the 8ft distance from the main router or master ONT.
Quick Tip: You also need to ensure that the BrosTrend extender’s Power button is set to the ON position.
2. Reboot the Devices
You should now try rebooting your BrosTrend extender as well as the main router. If will kick out all the technical glitches that might be causing problem. However, this hack will only be effective when the network name (SSID) of your BrosTrend extender is not appearing on any device. You must power cycle a particular device if your BrosTrend WiFi extender not showing up on the network list.
3. Verify the Wireless Settings
WiFi extender still not showing up in the network list? Well, it might be because you have disabled the SSID broadcast. Therefore, verify the wireless settings of your BrosTrend extender and check the same.
You can do the same by logging in to the range extender through the default web or IP address.
4. Update Firmware
Firmware updates play a vital role when it comes to the functioning of networking devices. Perhaps, your BrosTrend extender also needs a firmware update. Therefore, access the local interface of the extender from a device hardwired to its LAN port and see if a new firmware version is available or not. If yes, then follow the prompts to install the latest firmware.
5. Reset the Extender
Performing a factory reset on the BrosTrend extender should be the last resort. This needs to be done because some wrong settings might be preventing the extender’s SSID from appearing on the network list. To erase all settings at once, perform a factory default reset by pressing and holding the Reset button for seven seconds.
Conclusion
This was all about what to do if your BrosTrend WiFi extender is not showing up on the network list. We hope everything will be fine after following the given troubleshooting techniques. By figuring out the power, SSID, and firmware-related issues, you will be able to fix the problem permanently.