How to Use WPS button on BrosTrend WiFi Booster?

Every WiFi user wants a reliable network connection in his/her house. WiFi range extender, signal repeater, and booster helps to do that. Here, you will get to know about BrosTrend WiFi extender and how to use the WPS Button on BrosTrend device.

Setup Through WPS Button

The BrosTrend booster can easily be connected to the WiFi network with the help of the Ethernet cable as well as without any cable. Let’s see how to use the WPS button to connect the extender to router without cable;

Power On Extender and Router

You have to the plug the extender near to the router and power it on by pressing the Power button. Also make sure the router is connected to the power and receiving the internet signals.

Press WPS Button on Devices

Now, just find the router WPS button, press it, then within the 2 minutes you have to the press the WPS button on the extender.

Finish Connecting Devices

The WiFi router and BrosTrend extender will connect to each other automatically. After that, you have to configure the extender by following some of the steps given below.

Time to Configure BrosTrend Device

To adjust the settings of the brosTrend extender, you just have to the connect your computer to the extender network, and follow some steps;

• Connect your computer to the extender with LAN cable.
• Then, go to the updated web browser and enter http://192.168.0.254 or http://re.brostrend.com and search.
• By searching the URL or IP address you will reach to the login page of the admin interface.

• On this page, you have to enter the username and password on the fields and click on Log In button.
• Interface dashboard will open up on the computer screen, where you can easily adjust the settings.

You must adjust the frequency settings, change WiFi password, and change admin login credentials from the interface.

Troubleshooting Tips

Reboot

The other tip to solve the any problem relate to the BrosTrend extender is to reboot it. Just have a look how to restart the device;

• Plug out its power cord from the wall socket and plug it again.
• Turn it off and again power it on by pressing the power button.

Reset

You should reset the brosTrend WiFi extender to fix the mentioned problem;

To reset the device, you have to find the reset pinhole button on the back and with the help of the pin or sharp object.

After that, all the settings and data will deleted and you have to set them up by logging in to the re.brostrend.com or 192.168.0.254 interface.

The End Note

Here, you have get to know about how to use the WPS button on BrosTrend extender and how to setup the device with it.